I think I have this video done, but might have not made it public.
I bought the extra set of hood pins to keep my Owner's Kit intact. Well, it had all the extra grommets....needless to say I felt robbed.
I had heard of guys scuffing the cover plates so I was happy to have a spare set and it was really just the lanyards I wanted (rest was already installed). I went ahead and fitted the grommets and they fit the hole, but the "upfit" plant must have not had the jig placed correctly on my hood because it will fit the hood, but when you shut it, the grommet will stay on the hood pin...very frustrating. Sometimes if they don't "plant on the pin" you can raise the hood and they'll fall off.
I may try the part you listed, but I know my hood was not drilled straight. If you shut it, you can see more of a gap towards the forward side of the scuff plate than the rear (windshield side). It isn't off much, but just enough to make it noticeable to someone who truly cares. I would bet this was common with a lot of the hoods. I know several have complained of the waves where the scoop joins.
I'll research where I left off with that vid. The reason I had it private was bc I couldn't finish the install with the grommets coming off all the time
